From Department of Agriculture, Food and the Marine
Published on
Last updated on
1. The raw materials used in the production of horns and horn products (excluding horn meal), and hooves and hoof products (excluding hoof meal), for the production of organic fertilisers or soil improvers must be sourced from Category 3 materials referred to in Article 10(a), (b), (h) and (n) referred to in Article 10 in Regulation (EC) No 1069/2009.
2. Horns and horn products and hooves and hoof products can be imported provided that they:
• Are accompanied by and conforms with the requirements of an agreed animal/public health certificate
1. Horns and horn products (excluding horn meal), and hooves and hoof products (excluding hoof meal) for the production of organic fertilisers or soil improvers may be exported to the EU from any Third Country.
2. Lists of approved establishments may be found here (Animal by-products: Section III).
3. The products must:
• Originate from animals that were slaughtered in a slaughterhouse, after undergoing ante-mortem inspection, and were fit, as a result of such inspection, for slaughter for human consumption
or
• Originate from animals that did not show clinical signs of any disease communicable through that product to humans or animals
4. The products shall comply with the requirements set out in Section 12 of Chapter II of Annex XIV in Regulation (EU) No. 142/2011.
5. The product must have a label indicating “NOT FOR HUMAN and ANIMAL CONSUMPTION”.
6. Products derived from bovine, ovine or caprine animals must meet the relevant requirements of Regulation (EC) No. 999/2001, which lays down the rules for the prevention, control and eradication of TSEs.
7. Horns, horn products, hooves and hoof products must have undergone a heat treatment for one hour at a core temperature of at least 80° C.
1. Horns and horn products (excluding horn meal), and hooves and hoof products (excluding hoof meal) for the production of organic fertilisers or soil improvers shall be presented at a Community Border Inspection Post accompanied by a veterinary health certificate, drawn up in conformity with the model certificate found in Chapter 18 of Annex XV in Regulation (EU) No. 142/2011.
2. The certifying veterinarian should ensure that only the relevant paragraphs and, where appropriate, additional guarantees and/or special conditions applicable to the exporting country are included.
1. Consignments of animal by-products entering the EU must be inspected at an EU-approved Border Control Post (BCP) where Member States' official veterinarians ensure they fulfil all the requirements provided for in EU legislation.
2. The operator responsible for the consignment must give the BCP at the intended point of entry advance notification of the arrival of the consignment.
3. There is a required minimum pre-notification notice period of at least 24 hours’ notice in advance of the consignment’s arrival.
4. Failure to submit correct documentation within this timeline may result in significant delays in the consignment being processed through the Border Control Post.
5. Pre-notification is given by the submission of Part 1 of the Common Health Entry Document (CHED-P), as is laid down in Commission Implementing Regulation (EC) No. 2019/1715, through the online TRACES NT system.
6. Other supporting documentation associated with the consignment should be submitted at this time as well - such as the health certificate, invoice, packing list, bill etc.
1. Providing all the documentation has been submitted correctly and within the correct timeframes, a large proportion of the documentary check can be commenced in advance of the consignment’s arrival. This includes examination of the veterinary certificate and other documents accompanying a consignment.
a.Please note the original hard copy of the health certificate must travel with the consignment, this will be checked and held at the BCP at the point of entry into the EU.
2. Provided all is in order with the documentary check, the consignment will then be subject to an identity check at the BCP to ensure it identifies with the consignment that was declared in the documentation.
3. A proportion of consignments will be selected for a full physical inspection with/without sampling as appropriate.
4. Upon satisfactory completion of the required checks, the decision is entered in Part 2 of the CHED which must accompany the consignment to the first place of destination referred to in the CHED.
5. If the consignment does not meet the import requirements, the consignment may be rejected and either re-exported or destroyed.